Grapevine Gate Repair

Almost always a safety device: a blocked or misaligned photo-eye, a faulty edge, or a vehicle loop stuck in detect. Nothing is wrong with the motor; the sensor needs service.

Texas clay swells and shrinks with the weather and takes posts with it. We re-set and reinforce posts so gates hang true again instead of shimming the hinge every year.

Yes. We install breakaway arms that pop free instead of snapping, add articulated arms where ceiling height is an issue, and tune the loop and timing so the arm does not drop on slow-moving vehicles. A written price covers the arm hardware and the operator adjustments together.

Often. We clean and reseal the foundation box, improve drainage around it and replace the operator if the motor or gearbox has corroded. If the box location cannot drain, we will price an articulated-arm operator that keeps the electronics above grade.

Very likely. A surge usually damages the control board, and boards can be replaced on almost every operator. Adding surge protection helps avoid a repeat.

It depends on the failure. Adjustments and small parts are inexpensive, while boards, motors and structural work are the bigger tickets. We put the exact price in writing first.

Gate installation costs depend on size, style, and automation, and the gate material matters just as much. Basic setups usually land around $1,200 to $7,000 total, with smaller entry-level projects sometimes around $700 to $900; manual gates often run about $1,000 to $6,000, a typical automated driveway gate is often $4,000 to $7,000 installed, retrofit automation commonly adds $1,200 to $3,500, and high-end custom motorized gates can run from $7,500 to over $16,000. Running power lines to the operator means trenching, and site conditions can increase labor and push the total higher.

That depends on your layout, clearance and how you use the entry. We install swing, sliding, and bi-fold gates, and we can identify the best fit based on slope, width and daily traffic. We also flag common issues up front, like a leaf that drags, poor support, or an opening that does not leave enough room for the gate to travel cleanly.

They can. In some Grapevine neighborhoods, HOA approval may affect the style or materials you can use, and motorized gates may need permitting for safety compliance. North Texas clay often calls for deeper excavation, and heavy gates need deep post footings for long-term stability.

Yes. LiftMaster, DoorKing, Viking, Eagle, All-O-Matic, Nice/Apollo, HySecurity, Mighty Mule, Ghost Controls, US Automatic and more, residential and commercial.

Usually, yes, if the gate and posts are structurally sound. Automatic gates add convenience compared with manual gates. We start with an inspection to confirm the structure is worth upgrading, then add the operator, safety devices and access control to what you have.